|
Installed the new control panel and now it shows F31/ Tech sheet does not show it. Any ideas?
|
|
I got the new control board and now it gives me a code of F31, any ideas what that is? Thanks
|
|
I ordered the control board today.
|
|
Do you have good air flow out the exhaust? Check the blower belt. May be blockage inside the blower housing. Did you replace the control board?
Eric
|
|
I cleaned the lint housing and all areas I could see lint build up. After putting it back together and running it I found another issue. After about 40 minutes of dry time the lint sensor light goes on and the beeper goes off. After inspecting the lint trayy nothing is found. Then start again and after about 40 minutes the beeper goes off with the lint light activated. Any ideas on this one? Thanks
|
|
|
|
F1 code, so do I need Electronic Control Board replaced?
|
|
Get the tech sheet out of the machine and put the dryer into service mode to check for error codes. There are two thermistors and you don't do a continuity check on them, you check their resistance. The resistance depends upon their temperature. Use the chart on the tech sheet for comparison. Also I would clean the moisture sensor strips to make sure they are not shorting out due to contamination. These are used in auto dry cycle to tell the control board the dryness of the clothing.
Eric
|
|
I did a continuity test on the Dryer Thermister, Thrmst-Fix, and found they are good
|
|
Auto dry cycle will start at 40 minutes then will recycle and dry indicating 99 minutes
|