Ninja
Well, I checked the float switch, manually it moves up and down okay. I took the leads off and checked continuity, that seemed okay also.
I plugged the connector in and turned on the dishwasher.
The top of the connector had a red and white wire, the middle connector had a single gray wire, and the bottom had a single white wire.
With the dishwasher on and the connector plugged in, I checked voltage where the wires went in.
I had 120 volts between the red/white and single gray. Also had 120 volts between the single gray and single white wire. (top prong/middle prong & bottom prong/middle prong)
0 volts between the top red/white and bottom single white wire.
120 volts from top red/white to ground and 120 volts between bottom single wire and ground.
Not sure where to go from here.
Thanks again