Rank: Member
Groups: Registered
Joined: 7/22/2012(UTC)
Posts: 3
|
I replaced the thermistor and still have the same problem. Any thoughts on what I should try next?
|
|
|
|
|
|
Rank: Advanced Member
Groups: APP Team
Joined: 2/12/2012(UTC)
Posts: 5,556
|
Hi.
Clean the lint, make sure there is no restrictions in the air flow.
Thank you.
Simon.
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 7/22/2012(UTC)
Posts: 3
|
Thanks Simon,
I checked for restrictions and the vent is unblocked. I have also delinted the entire dryer.
The dryer usually will do one load and not shut off. However the second load will stop, shut off, read E1 as an error message, over and over again.
I've done a panel test, which passed, and a door test which was good.
Should I try to take the control panel apart and check any measurements?
|
|
|
|
|
|
Rank: Advanced Member
Groups: APP Team
Joined: 2/12/2012(UTC)
Posts: 5,556
|
Hi.
What is the model number of the dryer?
Simon.
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 7/22/2012(UTC)
Posts: 3
|
|
|
|
|
|
|
Rank: Advanced Member
Groups: APP Team
Joined: 2/12/2012(UTC)
Posts: 5,556
|
Hi. Run the dryer for one cycle without the vent attached at the back. See if that make a difference. Check the thermistor harness and connection at the control board. If the dryer without the vent acting the same and the harness checks out good - replace the control board Part number: 8566150
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
