Maytag LSE7806 stacked laundry fills, then nothing. - Appliance Repair Forum

Welcome Guest! You can not login or register.

Notification

Error

Maytag LSE7806 stacked laundry fills, then nothing. Options Email this topic Watch this topic Print this topic » Normal Threaded
Model: LSE7806ADE	Brand: Maytag	Age: More than 10 years
Previous Topic Next Topic

GP38-2		#1 Posted : Wednesday, September 7, 2016 6:24:00 PM(UTC)
Rank: Member Groups: Registered Joined: 6/19/2015(UTC) Posts: 6		This washer stopped in the middle of cycle. Now it will fill, then nothing. The motor does not even hum. Just sits there after filling. Water level selector switch working properly. Transmission and belts are fine. Nothing stuck between inner and outer tub. Don't think it's a lid switch issue as the fuse is still good. Thinking maybe motor or timer. How would I narrow it down? Any other suggestions? Thanks


User Profile View All Posts by User View Thanks

Sponsor

See inside of your appliance - diagrams and part photos for virtually every model.

cbmserviceguy		#2 Posted : Thursday, September 8, 2016 8:16:24 AM(UTC)
Rank: Member Groups: Registered Joined: 3/28/2016(UTC) Posts: 200		The lid switches on these units are a known issue. They do not always blow the fuse. It depends what failed. There is a lid switch and a check switch. Take the top off the washer and ohm the switches. Below is the kit to fix it. It comes with both switches and such. Whirlpool 12001514 Switch Assembly with Fuse - AppliancePartsPros.com


User Profile View All Posts by User View Thanks

GP38-2		#3 Posted : Thursday, September 8, 2016 5:39:21 PM(UTC)
Rank: Member Groups: Registered Joined: 6/19/2015(UTC) Posts: 6		Thanks very much! Good to know. I was thinking if either the lid or check switches were bad, they would blow the fuse. Is there a trick to getting the top completely off? I'll ohm them out and get back. Thanks again!


User Profile View All Posts by User View Thanks

GP38-2		#4 Posted : Wednesday, September 14, 2016 9:18:09 PM(UTC)
Rank: Member Groups: Registered Joined: 6/19/2015(UTC) Posts: 6		Switches were good, but the spring loaded switch activator was binding.


User Profile View All Posts by User View Thanks

cbmserviceguy		#5 Posted : Thursday, September 15, 2016 3:54:48 AM(UTC)
Rank: Member Groups: Registered Joined: 3/28/2016(UTC) Posts: 200		They have a complicated design as far as lid switches go. That's why they tend to have a lot of issues. Glad to hear you got it all figured out!


User Profile View All Posts by User View Thanks

Users browsing this topic
Guest (2)

Forum Jump

You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.

Important Information: The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies. More Details Close