Rank: Member
Groups: Registered
Joined: 10/22/2009(UTC)
Posts: 1
|
I am replacing the fill valve assembly and is there a trick to get the clips off of the cylinoid? I've tried everything and they will not budge.
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 2/29/2008(UTC)
Posts: 19,638
Thanks: 1 times
Was thanked: 11 time(s) in 11 post(s)
|
I am assuming by solenoid you mean the one holding the tubing that goes to the pump from the water valve. The trick is to get the right set of pliers that have fairly heavy teeth. Needle nose are usually no good because the teeth are too small and does not hold the ring solidly. Get the ring ends in the teeth, close them and pull the ring straight back. There are probably pliers made especially for this but I have a set of small slip joint pliers that does the job. I use the teeth in the center part File:Pliers slip 01CJC.png - Wikipedia, the free encyclopedia |
THIS FORUM IS DEAD!!!!!!! |
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
