Rank: Member
Groups: Registered
Joined: 10/15/2009(UTC)
Posts: 2
|
I have had this dishwasher for 2 1/2 years and now has broken for the second time. Once at 1 1/2 years, of course out of warranty. The soap door would not open at that point, now the "Normal" button will not work. The other buttons seem to work but the dishwasher just shuts off after a minute or so. Any ideas?
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 2/29/2008(UTC)
Posts: 19,638
Thanks: 1 times
Was thanked: 11 time(s) in 11 post(s)
|
Here are the parts Replacement parts for WHIRLPOOL KUDK02CRBS3 | AppliancePartsPros.comHere is the tech sheet http://www.servicematters.com/d...heet%20-%20W10082651.pdfThe Normal key not working could be just the keypad. The tech sheet show how to check it with a meter. Try the connector cleaning shown below. The stopping during the cycle on the other cycle options is more perplexing. Sounds like the unit is waiting for a signal input and either is not receiving it or interpreting it incorrectly. Try running the diagnostics to narrow it down. Connector Cleaning Unplug the unit Open it up Remove the ribbon cable from the keypad to the control board at the control board. Clean the edge connector. If it is the type where there is not a connector just the insulation is removed, it can be cleaned with a pencil eraser. Do not use an ink eraser as it is too abrasive. Check the tracks in the ribbon cable for hairline cracks. A magnifying glass helps here. Would not hurt to clean the connector on the board. Use electronics contact cleaner or isopropyl alcohol and a tooth brush. Be gentle and do not reconnect till all the solvent evaporates. Reconnect everything and give it a try. |
THIS FORUM IS DEAD!!!!!!! |
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 10/15/2009(UTC)
Posts: 2
|
Thanks. Funny thing is.....after looking at all the dishes I had to do. I tried the dishwasher and it worked just fine this morning. I am not sure what is going on.
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 2/29/2008(UTC)
Posts: 19,638
Thanks: 1 times
Was thanked: 11 time(s) in 11 post(s)
|
This does sound like a dirty contact/connector often this will cause an intermittent problem. |
THIS FORUM IS DEAD!!!!!!! |
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
