Rank: Member
Groups: Registered
Joined: 10/12/2009(UTC) Posts: 3
|
Diswasher only displays Quick clean up cycle and Energy saver dry. cannot change cycles or dry modes. 4 hour delay seems to still work. Any suggestions?
|
|
|
|
Rank: Member
Groups: Registered
Joined: 9/26/2009(UTC) Posts: 12
|
Other posts have noted similar problems with the control panel the control lock is activated. If so hold air dry down for 5 - 10 seconds to release the lock.
|
|
|
|
Rank: Member
Groups: Registered
Joined: 10/12/2009(UTC) Posts: 3
|
Control lock works fine. Tried multiple times to switch cycles but no luck. Originally Posted by: csager  Other posts have noted similar problems with the control panel the control lock is activated. If so hold air dry down for 5 - 10 seconds to release the lock.
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 2/29/2008(UTC) Posts: 19,638
Thanks: 1 times Was thanked: 11 time(s) in 11 post(s)
|
Here are your parts Replacement parts for WHIRLPOOL KUDS01DLSS0 | AppliancePartsPros.comHere is the tech sheet run the diagnostics. http://www.servicematters.com/d...0Sheet%20-%208533399.pdfClean the connections as shown below. Check the keyboard with a meter. If the keyboard checks out OK then the control board comes to the top of the list as the cause. Connector Cleaning Unplug the unit Open it up Remove the ribbon cable from the keypad to the control board at the control board. Clean the edge connector. If it is the type where there is not a connector just the insulation is removed, it can be cleaned with a pencil eraser. Do not use an ink eraser as it is too abrasive. Check the tracks in the ribbon cable for hairline cracks. A magnifying glass helps here. Would not hurt to clean the connector on the board. Use electronics contact cleaner or isopropyl alcohol and a tooth brush. Be gentle and do not reconnect till all the solvent evaporates. Reconnect everything and give it a try. |
THIS FORUM IS DEAD!!!!!!! |
|
|
|
Rank: Member
Groups: Registered
Joined: 10/12/2009(UTC) Posts: 3
|
Thanks for the tech sheet, I will try to use it and your advise this weekend. Thanks once again!
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 2/29/2008(UTC) Posts: 19,638
Thanks: 1 times Was thanked: 11 time(s) in 11 post(s)
|
You are welcome
Please let us know how it goes. |
THIS FORUM IS DEAD!!!!!!! |
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close