|
Thanks so much for the quick reply! I THINK my motor is ok- if I tested it correctly... so I guess I'll gamble on the control board. Thanks, again!
|
|
It needed a motor and motor control board. I bought a new washer.
|
|
I have the exact same model and mine won't spin at all. Only error code is E20. SOOO frustrated!!!
|
|
Entered the test mode and got the following error messages:
Er:20 Spin Cycle Terminated, No communication between control and inverter, Unbalance too high, check wire harness, check load
dr:08 Speedometer Failure, Damaged speedometer, check wire harness
dr:10 Power limiter switch off, too heavy load, mechanical friction, check oscillating system, check gasket, check load
dr:11 Voltage too low, weak power supply, check line voltage
Given the above, is this something that can be repaired and if so, what parts are needed?
Thank you
|