|
I did find a sheet there. I'll check it out and let you know what I find.
Thanks for the help.
Artie
|
|
Unfortunately I could not find the tech sheets for this model.
Check behind the bottom panel - it could be there. If you'll find it, just follow the instructions written there.
Gene.
|
|
Gene, is there any way to test this part? I have a good volt/ohm/ammeter.
Thank you for your help.
Artie
|
|
Most likely the problem caused by the push button switch. - The part number for the push button switch is AP3096909 Gene.
|
|
Well, I had pulled that plug before, but I looked at it again. It isn't a blade type plug. It is a pin type plug, and I couldn't clean it with an eraser. I looked at the plug and the pin terminal with a bright light and a magnifier and they are clean. Still doing the same thing.
Another person had suggested testing the switches on the latch. They tested good. Is there a reset method on this unit that I should know about? I have turned the power off for more than an hour with no results.
Any other ideas?
Thanks, Artie
|
|
Hi Artie,
Remove the inner door panel and the cover. Unplug the ribbon from the power board and clean it, using an eraser.
Plug it back, assemble the door and see if it's working.
Gene.
|
|
I'm pretty sure that's the model number in my previous post. Got any suggestions?
Thanks, Artie
|
|
OK, I just found this. 15838791. It is barely visible and it wasn't exactly in the same line at the 665. Is that it?
Artie
|
|
There is a manual suplement that was inside the front cover. The number on it is 3381341
Artie
|
|
Artie,
It suppose to be 7 to 8 more digits after "665". If they are missing I probably could not help you as much as I would like.
Gene.
|