|
|
Turning the power off at the breaker for a few minutes seems to reset everything, and I can get one or more wash cycles to run. After that it acts just like before. Water comes in nothing happens, half an hour or so later water goes out but nothing was washed. Even the soap that fell from the dispenser is crusted on to the bottom of the door.
|
|
|
The wash cycle will "start" and water will flow in. After that nothing happens, and there is a slight smell (almost like plastic getting hot). I have not noticed anything odd before this week, and then it just didn't wash the next load. Was working well before with no noise or other out of the ordinary signs.
So, why is my wash cycle not running any water through the jets?
|
