Originally Posted by: ramszhang I bought a replacement motor for my washer which came with a pully , evidently, permently placed on the shaft. I can not figur out how to get thei motor into the space the old one came out of which had a removable pully. Anybody know how?
Here are the instructions from the service manual:
To Service Motor/Clutch
1 remove front panel,access motor and clutch from front.
2 Loosen (4) 3/8" nuts on leg and platform assembly
(underside of platform).
3 Move motor towards the center of the platform to release belt
tension,and remove belt.
4 After removing 4 motor mount bolts, rotate transmission to a position
that allows you enough clearance to pull the motor out by moving the
bottom forward to allow the assembly to clear the platform.
5 The clutch is mounted on top of the motor with a one shot removable
clutch spring clip that engages the flats in the motor shaft
To remove the clutch, remove the clip and lift the clutch up.
6 Reverse and repeat previous steps to reassemble.
Hope this is what you were looking for.
:) :) :)