Rank: Member
Groups: Registered
Joined: 5/25/2010(UTC) Posts: 1
|
Washer wont spin. Motor seems to check out ok. (with meter on windings ohms change when rotor manualy spun on each phase). The control board is ptutting out 160VDC going to windings. Gut feeling is to replace the board. Any ideas?
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close