Rank: Member
Groups: Registered
Joined: 4/25/2010(UTC) Posts: 3
|
Washer fills with water, then stops. Will not start agitating.
|
|
|
|
Rank: Member
Groups: Registered
Joined: 4/24/2010(UTC) Posts: 5
|
Will the washer spin if advanced to the spin cycle.
|
|
|
|
Rank: Member
Groups: Registered
Joined: 4/25/2010(UTC) Posts: 3
|
Originally Posted by: busch Will the washer spin if advanced to the spin cycle. washer just fills with water. Will not do anything at all when i advance the knob.
|
|
|
|
Rank: Member
Groups: Registered
Joined: 4/24/2010(UTC) Posts: 5
|
id say you have a bad control timer.
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert, Administrators Joined: 7/19/2007(UTC) Posts: 27,455
Was thanked: 4 time(s) in 4 post(s)
|
Originally Posted by: missychuck Washer fills with water, then stops. Will not start agitating. The first thing I would do is check the water level/pressure switch (#21 in the diagram). If you found the wiring diagram (usually inside the control panel), post it to figure out which terminals should be checked for continuity. - The water level/pressure switch Part number: AP4024620
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close