Replacing washing beaings/pully rubbing in to tub???!!!
Model Number: MAH5500BWW Brand:
More than 10 years
Okay, so I have done my research and watched all videos I could. I think I am okay when it comes to the general replacement of the bearings.
What I am not sure about is the places where the pulley has been rubbing against the tub. I have attached pictures. The spacer that is supposed to be there was not on the pulley when i removed it, not sure it that has something to do with it or not.
I did notice that the rear bearing is pushed in and there is a gap on the edge of the inside where the bearing goes. Is it possible that the pulley was pushed in to far and that is why it is rubbing against the tub? I have attached pictures of the gap I am speaking of as well.
Any help would be appreciated.