|Register | FAQ's | New Posts | Today's Posts | Extras|
Clicking sound on Start of Rinse Spin
Model Number: Kirkland/Whirlpool SAWB600HQO Brand: Whirlpool Age: More than 10 years
I have a 1999 Kirkland/Whirlpool SAWB600HQO It makes a clicking sound on the startup of the Rinse Spin Cycle. This is a new sound and not one that was present before my repair. Other than that the machine works fine and sounds normal even on other spin cycles. The clock goes through the cycles and does not get stuck.
I just replaced the following due to Non - Agitation and a transmission that was very hard to turn by hand by putting vise grips on the motor shaft.
3) Motor Coupling
4) Motor and Cap
Here is short video of the sound and it goes away near the end as most of water is pumped out.
Any ideas where to look for the problem ?
Update: I just did a lighter load and there were no issues everything sounded and worked normally
Last edited by Mrlocksmith : 04-20-2017 at 11:10 PM.
See inside of your appliance - diagrams and part photos for virtually every model.
powered by AppliancePartsPros.com
|Thread Tools||Search this Thread|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Clicking sound after start relay replacement||mmr159||Refrigerator & Freezer Repair||1||03-29-2017 04:44 PM|
|clicking sound during spin||allen9258||Washer Repair||1||12-18-2013 02:35 PM|
|Intermittent Spin... Clicking Sound & Smells||atoth22||Washer Repair||1||07-10-2011 06:17 PM|
|Washer doesn't spin...drains and makes clicking sound||rcorley||Washer Repair||1||02-23-2010 05:37 PM|
|washer makes clicking sound and now won't spin at all||LKelly||Washer Repair||2||10-25-2008 07:36 PM|