Rank: Member
Groups: Registered
Joined: 6/24/2010(UTC)
Posts: 2
|
Hello, My washer is an older Kenmore Model 110 - 82873120. As it cycles, when it comes to rinse or spin, the agitator doesn't move but you can hear what sounds like the motor humming/spinning. If I shut it off with the knob then immediately turn it back on, it makes a loud click, then will start spinning. Everything else works OK - fill, drain, agitate, etc. But the spinning cycle needs this manual assist. Any ideas? Thanks, Aaron abergman@live.com
|
|
|
|
|
|
Rank: Advanced Member
Groups: Expert
Joined: 7/27/2010(UTC) Posts: 1,395  Location: near the middle of nowhere Was thanked: 24 time(s) in 24 post(s)
|
A couple of questions.
How cold does it get in the area you have your washer in?
Do you ever do warm or hot loads?
Does your washer pause after the drain part of the cycle, before it goes into the spin part of the cycle?
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
