Rank: Member
Groups: Registered
Joined: 8/30/2015(UTC) Posts: 1
|
I recently replaced my control board due to no spin and no door lock problems. I also replaced the wax motor even though I had a black tipped one in the machine. NOW the machine refuses to unlock the door, even after unplugging it. I have been using the filament emergency cord to get it to release. Not fun, but Im worried about the cord snapping off and then what?? Can anyone tell me if it is the ribbon spring that I may have pinched too tight when replacing it, or is it the door lock mechanism? This washer has about 15 yrs on it, so I really need to baby it along a little while longer.
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close