Rank: Member
Groups: Registered
Joined: 5/17/2013(UTC) Posts: 2
|
Hi - I'm looking for a little help today.
I just had my washer apart and replaced the snubber pads because I had some vibration. Got it all put back together, plugged it in, put in a load of clothes, and it filled with water fine - then stopped. Nothing happening. If I move the dial over to a spot where it should be spinning or draining or something, still nothing.
Any ideas what I might have done? Or what I should check? I've kept this old baby alive for a long time, just ordered an agitator kit because i found that bad when I had it apart. Really don't want to buy a new washer today :o
Thanks for any help you can offer!
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close