Rank: Member
Groups: Registered
Joined: 11/15/2014(UTC) Posts: 1
|
Help! Whirlpool washer is experiencing the oh-so-common (where the hell's the recall!!!) lid lock issue. Wasn't sure if it was that or the shift actuator, so I was proactive and replaced both. I ran the diagnostic but I have no idea how to tell what's wrong. I ran the calibration mode too, ended on blinking lid lock for five minutes until it finally went off. So what gives? I've got laundry piled to the ceiling and a two-year old worthless POS.
What should I try next? If it's the board I think I'm just replacing it.
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close