|
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » control panel is out |
|
|
By reading any content on this site you agree to AppliancePartsPros.com, Inc. disclaimer and Terms of Use. |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
|
|||
|
Model Number: mah7500 Brand: Maytag Age: 1 - 5 years
my control panel is out the buttons won't work either but it is getting power when i open the door the light comes on. is my broad bad?
Thanks Bill, Ads By Google Related Models |
|
See inside of your appliance - diagrams and part photos for virtually every model. powered by AppliancePartsPros.com |
|
|||
|
See if you can get the machine into a troubleshooting mode. Yours is an updated Neptune, and here is the service manual for the basic machine. It has supplemental information on your model at the back.
http://www.servicematters.com/maytag...s/16010061.pdf If you determine that the control assembly is the problem I suggest you strongly consider replacing the machine rather than sinking the cost of a new board into this model.
__________________
- |
|
See inside of your appliance - diagrams and part photos for virtually every model. powered by AppliancePartsPros.com |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
|
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Control Panel or Electronic Control - which causes blinking panel lights? | MarcLCH | Dishwasher Repair | 1 | 02-25-2010 03:25 AM |
| GE Built-In Oven Control Panel - replace entire assembly or just control kit | boschuser | Oven Repair (including Ranges and Cooktops) | 1 | 01-05-2010 03:11 AM |
| tranformer blew on control panel need specs for new transformer not control panel | kaydog2009 | Oven Repair (including Ranges and Cooktops) | 0 | 05-11-2009 07:22 AM |
| Replace control panel or just control panel housing? | Max Strano | Dishwasher Repair | 1 | 08-26-2008 06:02 PM |
| Control Panel | gebhardtwf | Dryer Repair | 1 | 03-05-2008 05:25 PM |