Rank: Member
Groups: Registered
Joined: 2/22/2013(UTC) Posts: 1
|
Replaced bearings, shaft, seal with recommended installation tool due to loud noise on spin cycle--typical jet engine sound. Afterwards,turned tub by hand, no pop. On first wash load, there was a popping noise when the tub turned--about 1 pop/revolution. Removed tub but didn't find anything out of the norm. Did not notice anything unusual when replacing bearings, etc. Now tub pops when turning by hand. Turns smoothly and no bearing noise or pop during spin cycle, only during wash cycle, maybe rinse also. Any ideas--I'm baffled.
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close