Rank: Member
Groups: Registered
Joined: 2/18/2013(UTC) Posts: 4
|
morning all. just trying to trouble shoot a little before i drop some coin. i just replaced my tub seal and bearing and now my washer is acting up again. seems as if it skips the drain and spin cycle. i can turn the control knob back around and after about the 4th try it'll spin and drain. this happens on all modes, whites, delicates and normal. how do i tell if this is a timer issue (which i suspect) or a control board issue?
hate to drop 140 on the timer and find out its the control board. thanx all!!! toad
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close