Washer Repair

Berte · #1 (**permalink**) 01-12-2013, 03:43 PM

I have a replacement lid switch, and the connector is not the same. Can I splice the old connector onto the new switch?

If do, there are two gray wires and one green
En. Does it matter which gray I splice to which?

sidfink43 · #2 (**permalink**) 01-14-2013, 06:07 PM

The short answer is yes. Actually that's the long answer too. We do this all the time.

It doesn't not matter which gray is hooked to each gray as long as the green (ground) is to green.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
How to remove the switch panel to replace on off switch	Syd	Washer Repair	1	08-27-2011 06:21 PM
Door Switch and Switch Holder Replacement	gwlvservice	Microwave Repair	0	06-18-2011 03:58 PM
GE Oven - Which limit switch is one time thermal switch(two are close on diagram)	personalt	Oven Repair (including Ranges and Cooktops)	2	04-26-2011 04:57 AM
Maytag dryer switch went bad (I thought) but new switch is doing the same thing.	woof	Dryer Repair	1	11-19-2010 01:53 AM
infinite switch wiring change from 6 wires to 5 wire switch	wiedemanndds	Oven Repair (including Ranges and Cooktops)	5	11-24-2009 02:14 PM

Lid switch

Washer Repair

I have a replacement lid switch, and the connector is not the same. Can I splice the old connector onto