Rank: Member
Groups: Registered
Joined: 1/11/2013(UTC) Posts: 3
|
I am trying to find a replacement lid locking mechanism. The one on my washer is not holding the lid in full locked position, and causing the washer to stop running. There is nothing jammed in the lock itself, so I need the replacement. Any suggestions?
|
|
|
|
Rank: Advanced Member
Groups: Expert
Joined: 10/16/2012(UTC) Posts: 3,806
Was thanked: 7 time(s) in 7 post(s)
|
Here is the replacement lid latch. Are you sure it's the lid lock? What are the symptoms? Is the lid lock LED flashing? When you start a cycle, does it attempt to lock the latch? Eric
|
|
|
|
Rank: Member
Groups: Registered
Joined: 1/11/2013(UTC) Posts: 3
|
The Lid Lock LED does not flash, and the locking mechanism clicks repeatedly, about once every second or so. In testing the lid lock control pins on the motherboard, the 2 and 3 pins show sporadic resistance when the lid is closed, between 50 and 850 ohms.
|
|
|
|
Rank: Advanced Member
Groups: Expert
Joined: 10/16/2012(UTC) Posts: 3,806
Was thanked: 7 time(s) in 7 post(s)
|
Ok, well, you can actually get into that switch and clean the contacts if that's all the problem is. See my web page on that cheap piece of junk. Eric
|
|
|
|
Rank: Member
Groups: Registered
Joined: 1/11/2013(UTC) Posts: 3
|
I will definitely try that. Sounds like a solution to me.
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close