Rank: Member
Groups: Registered
Joined: 12/7/2012(UTC) Posts: 1
|
When I start a cycle, the tub fills and will start to agitate but will stop after a few minutes. I've set the dial to rinse/spin and no response. If I attempt a new load cycle, it will agitate again very briefly then stop. Please help : ) Gabi
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 3/29/2009(UTC) Posts: 11,699
|
Take off the front cover by inserting a screw driver in the gap between the top and front near the edges to release clips that hold the front panel on.
Then observe what happens when it stops. If the motor stops you may have a motor. wiring on control unit problem. If the motor continues then the problem could be the clutch or the transmission.
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close