Washer does not spin or tumble
Model Number: Whdvh626 Brand:
1 - 5 years
Need to know how to determine if its the control or inverter. When starting a cycle the drum will tumble twice voltage at motor reaches 200vac at tumble. Then when it should rotate again it only reaches 163vac no drum movement. T10,11,14 have no drum response. Voltage at p 9 pins 1-4 128,108,128,128 respectively and alway on on the control bd. 128 vac to inverter from red and blue wires. Haven't seen any replies here's more info. When the drum should rotate 200vac is needed. The init sequence 200 vac in present when drum rotated cow and cow. But vac was only 163 during each cycle and rotation is required. I did find ec48 and using a service manual found on line checked mtr windings 6 ohms all good (ec48 motor open). Ordered inverter...replaced.....washer is now working!
Last edited by Canalml : 12-12-2012 at 04:14 AM.
Reason: Additional information