[Turbobob]

The spin cycle begins OK, but sometimes hear a rapid clicking noise for a few seconds, then continues into spinning. After a few minutes, the Lid Lock light starts to flash, then eventually goes out with about 8 minutes on the display, then stays out and tries all over again, unsuccessfully.

I cleaned the pulley for the belt drive, reseated all of the connectors in the control panel and the motor and shifter area. The drive belt feels tight. I then ran a drain/spin cycle without any clothes in drum, and it went through fine. Loaded some wet clothes and ran the drain/spin cycle again, and the lid lock light flashed as before.

Seems like the drum won't spin properly with a small wet load in it, or something is not telling the drum to spin. Any thoughts?

I have the service manual and tried getting into the diagnostics as written, but cannot get into them for testing.

The section on testing the lid lift mechanism is also missing, so no luck there.

Has anyone experienced this issue with the spin cycle?