[made]

washer will not fiil ,Checked water hoses all ok water is running. Start timer in large load, push button to start no water starts washing

[denman]

Here are parts for a 110-20022011
Parts for Kenmore Washer 11020022011 - AppliancePartsPros.com

Although a 110-20022012 does come up at the Sear's parts site I cannot find info on it anywhere else. Sears does have parts breakdown diagrams, unfortunately they do not like yo share them with other sites. The parts for this unit will be available from AppliancePartsPros even though it does not come up when you search the site.

I believe the 2011 will be a close match to your unit.
The tech sheet is too large so I cannot upload it to this site but have uploaded is to another general data site, see the below link
Download 20022011.pdf

Your unit should have a separate water level/pressure switch so it is probably the same as the wiring diagram on Page 20 of the tech sheet.

Check the pressure switch.
Disconnect the hose from it.
If it now fills odds are there is a plug in the hose.
If this does nothing.
Disconnect one wire going to the actual switch.
If it now fill replace the switch (re: it's contacts are not opening.).
The reasoning for the above is that for some reason the unit thinks it is already full of water so does not open the valves and goes directly into agitate.

Try the diagnostics.