|
|||
 |
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » Motor will not start unless I pull on the belt |
 |
By reading any content on this site you agree to AppliancePartsPros.com, Inc. disclaimer and Terms of Use. |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
11-01-2012, 11:06 AM
|
|||
|
|||
Motor will not start unless I pull on the belt
Model Number: LSE7804ACM Brand: Maytag Age: More than 10 years
So the washer was making a humming noise. I opened the front panel, then I encouraged the motor by pulling on the belt (a little dangerous I know) but it will start right up and run till it turns off then when it try's to start again the same humming noise. It has a brand new motor and a brand new start capacitor. I also have taken both belts off to see if it would start without a load, it still would not start on its own. I'm stumped any help would be greatly appreciated.
Thank you for your time in advance. Ads By Google Related Models Last edited by Handyman2 : 11-01-2012 at 11:09 AM. 
|
|
See inside of your appliance - diagrams and part photos for virtually every model.
powered by AppliancePartsPros.com |
|
11-01-2012, 12:33 PM
|
||||
|
||||
Hi.
Most likely it's a bad timer. The motor is not getting 120VAC to it's start winding. The timer Part number: 33001034 Before replacing the timer check the connections at the disconnect plugs. Here are the breakdown diagrams and 07-Front Panel & Control Panel (7804ACM & parts for Maytag LSE7804ACM - AppliancePartsPros.com Post the results. Simon.
__________________
Find Appliance Parts at AppliancePartsPros.com - Largest inventory in the U.S. with 91% of all in-stock orders delivered within 2 business days. Thousands of photos and diagrams make it very easy to find the right part. Enter your appliance model here.
|
|
|
See inside of your appliance - diagrams and part photos for virtually every model.
powered by AppliancePartsPros.com |
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| PULL to start: no water. PUSH to stop: WATER! | gatsby | Washer Repair | 3 | 06-20-2011 06:20 AM |
| motor turns easily when I pull belt, but fault code manual says to remove belt first | kenrepair | Washer Repair | 0 | 10-21-2010 05:58 AM |
| Washer Pull Start / Push Stop Knob comes OFF! | jbueker | Washer Repair | 10 | 09-15-2010 06:34 PM |
| Pull to start woill not work | mohican | Dryer Repair | 0 | 06-23-2010 06:49 PM |
| Maytag Dependble - No Spin/Drain, Motr Hums - Belt Cn Be Rotatd by Hand 2 Start Motor | bluestreak | Washer Repair | 12 | 12-06-2008 01:53 AM |
Linear Mode
