Rank: Member
Groups: Registered
Joined: 10/1/2012(UTC) Posts: 1
|
Washer was making noise when spinning. i opened the bottom and found the tub shield loose laying inside. removed it. Don't really see where it goes or what it does even after looking at the schematic. is the tub shield a critical part or can I just button it up and run it without the shield?
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 3/29/2009(UTC) Posts: 11,699
|
I am not sure which part you are talking about either, but run it with the front panel off and if everything works fine you should be ok.
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close