Rank: Member
Groups: Registered
Joined: 8/7/2012(UTC) Posts: 3
|
when start is pushed in any cycle lid lock and fill lights come on, machine does nothing. lid lock is new (machine ran for 1 day after replacing). +5 and+13 supply voltages are present on main control.checked level control and fill valves lvl. cntr. is open and fill vlv. resistance is correct (no voltage) also cannot seem to be able to enter diagnostic test modes. after half second clicks on selector, push start and lid lock and fill lights come on. (have tried several times). what else to check? could main control be bad? help!!! some expert advice would be greatly appreciated. thanks
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert, Administrators Joined: 7/19/2007(UTC) Posts: 27,455
Was thanked: 4 time(s) in 4 post(s)
|
Very likely the main control board is the culprit but before ordering any part I would recommend to perform the test #1 as described in the attached file. - The main control board Part number: W10393470
Gene.
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close