[wyocwboy]

Bought a Set Whirlpool Roper Washer and Dryer. I replaced the water Vave with New, And the washer did'nt have a Lid Switch, So i bought 1 and installed. Before i installed either of these New Parts the Washer would Spin. without lid switch and NO water Hoses arttached to water supply. NOW with a Lid Switch on it and a New Water Inlet Valve when i plug it in then pull the switch to run anywhere on the cycles IT Trips the Breaker .NOTE I only had 1 Hose attached to the water inlet valve ,I was outside and Only had Cold Water atteched on 1 water inlet. I'm totally Lost on this ,Can you help me to find my problem? Or tell me what i could have done wrong? Oh this Washer does'nt have any settings for different temps, it only has a dial for small loads and large, and the different cylcles 3 cycles settings on the Timer Dial. Help Please Thank You.