Washer Repair

end of the road gang · #1 (**permalink**) 09-13-2009, 08:51 AM

I found a technical manual on this site for my washer, I went through all the diagnostics everything checked out except the resistance on the motor leads the tech manual said that it is suppose to read 16 ohms I got a reading of 31.9 ohms equally on p5-1 and p5-2 / p5-1 and p5-3, I got the same readings checking on the motor itself, is this enough difference to say that the motor is bad?

sidfink43 · #2 (**permalink**) 09-14-2009, 08:09 AM

When the resistance is out of range there is a series of additional steps listed.

Did you take them and what were the results?

denman · #3 (**permalink**) 09-14-2009, 10:21 AM

I believe your measurement is good
Each winding is 16 ohms so when using p5-1 to pins 2 or 3 you are actually measuring 2 windings in series for a total of 32 ohms.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Kenmore Oasis F1 Code	Vacy72	Washer Repair	8	01-03-2012 09:05 AM
F1 code Kenmore elite oasis toploading washer	JuliaD	Washer Repair	1	11-17-2009 04:48 PM
Oasis kenmore code F 50 appeared	lyzzzyl	Washer Repair	6	09-20-2009 11:39 AM
kenmore oasis he fault code F50	end of the road gang	Washer Repair	0	09-13-2009 05:49 AM
Kenmore Oasis Code F-54	richmond418	Washer Repair	3	05-04-2009 09:27 AM

kenmore oasis he fault code F50

Washer Repair

I found a technical manual on this site for my washer, I went through all the diagnostics everything checked out