Rank: Member
Groups: Registered
Joined: 6/8/2012(UTC) Posts: 1
|
Hi Everyone,
My washer just broke today (wouldn't agitate; though it is agitating me! har har har ;-) so, being the handy person I am, I jumped on-line and saw one of Gene's posts about "Whirlpool Direct Drive Washer Motor Coupling" which is exactly what the issue was. So, I ran out and picked one up. I got it installed no issue and fired up the washer and voila, it was agitating! I was very happy!! Then about 5 min into the cycle it started to emit this very loud squealing noise and I smelled what might have been rubber starting to burn, so I shut it off and disassembled again to see if I may have done something wrong. I had not.
So, that said, my question is this, I am now assuming that the washer motor coupling broke not because of the load of towels in the washer but rather, there is something else amiss. Any ideas what I should be looking for? The motor seemed very hot when I removed it this second time, so something is putting it under a lot of stress me thinks.
Would love to hear any ideas anyone has...
Cheers, Ted
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close