Rank: Member
Groups: Registered
Joined: 1/22/2008(UTC) Posts: 1
|
Hello, I hope someone can help me. My whirlpool washer (Purchased used/repaired so the model number is removed) started acting funny durring the Spin mode. Looking at many repair sites I confirmed that it wasnt the door switch and started playing with the timer. I noticed that if I pulled up on the timer knob or turned it off and on the spin cycle would start up. I was told that the motor in the switch could be going bad, so I decided to open the timer ( Part Number 3951166B). When I did that, a small spring popped loose and I cant figure out how the spring is supposed to go back in. I have included a picture of the disasembled timer and an arrow pointing to the area/post the spring was on. Can you tell me what part/arm the spring was connected too? Can you send me a diagram? Maybe a picture of a complete one? Any help would be apreciated. Rock rocknthenard attached the following image(s):
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close