[23cats]

I have a washer with an intermittent power enabling problem. The machine quit in the middle of a wash cycle last night. I find that if I shake the wire harness that I can get flashes of indicator lights bu I have not been able to find an exact location that would indicate where the problem lies.

I have checked the controller and it has the low voltage power at all times but that is as far as I can go with it unless I take the unit out and make a diagram of the board and another one of the whole washer. I hope that someone could tell me where I could find the diagrams on the net.

I have very little money and must do the repair my self. I am knowledgeable electrically as well as electronically. I am a retired ee.

If the board is bad I would need to replace it and I have been unable to locate one at this time. Yet all of my testing does not indicate that the problem is in the controller.

Thanks - 23Cats

[richappy]

It just might be a bad control module AP3859567 From the picture it does not seem like you can take it apart to get at the bare pc board. It is quite possible a power device like a relay has unsoldered itself.
If you decide to check it, be aware, some boards are static sensitive and you can blow it out if not carefull. I used gloves on my last job handling one.
Best to check aqll connectors first to isolate the intermittant.