|
|||
 |
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » Door latch assembly or user interface? |
 |
By reading any content on this site you agree to AppliancePartsPros.com, Inc. disclaimer and Terms of Use. |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
08-07-2007, 04:54 PM
|
|||
|
|||
Door latch assembly or user interface?
Model Number: GHW 9200LQ Brand: Whirlpool Age: 1 - 5 years
The waher seems fine when selecting a cycle. All appropiate LEDs light up but the machine will not start(the door does not latch electronically. I tried to reboot it by following the reboot protocols. however the Led will only go down to 2 minutes it will not clear. I tried to leave the machine unplugged for hours not minutes.
    
|
|
08-10-2007, 10:15 PM
|
||||
|
||||
|
CMC1
Run the diagnostic test described in the technical data for your washer. It should be supplied with your washer but if do not have one you can find it here: Service Matters - Tech Sheets / Wiring Diagrams Gene.
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| detergent release latch | linjarob | Dishwasher Repair | 1 | 10-03-2007 09:08 PM |
| Maytag Front loader door latch assembly | bpcolll | Washer Repair | 4 | 08-29-2007 09:55 AM |
| Removing rear bearing above brake assembly | Scott | Washer Repair | 2 | 08-04-2007 09:55 PM |
Linear Mode
