Rank: Member
Groups: Registered
Joined: 12/11/2011(UTC) Posts: 1
|
How do I check mode shifter coil?
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 2/29/2008(UTC) Posts: 19,638
Thanks: 1 times Was thanked: 11 time(s) in 11 post(s)
|
A model number may help others help you. Model Number LocatorI am assuming you are talking about a solenoid. Unplug it and measure it for resistance. If it is open it is toast. I am not sure whet the resistance should be. Remove it and check that it works OK mechanically. |
THIS FORUM IS DEAD!!!!!!! |
|
|
|
Rank: Member
Groups: Registered
Joined: 3/28/2009(UTC) Posts: 1,648
|
If your mode sifter has failed the spin basked will rotate back and forth during the wash cycle as apposed to just the agitator moving. You will also get the four flash error code on the motor. To confirm disconnect the sifter from the motor and test ohms across the two wires, you should get about 98 ohms give or take. This page has a section about checking the mode sifter (sifter coil). HydroWave GE Washer Repair Guide
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close