Rank: Member
Groups: Registered
Joined: 3/5/2009(UTC) Posts: 1
|
Just started a few weeks ago. Washing a load and the clothes come out fuzzy. Not like lint so much, but like you ran the clothes over sandpaper, or sandpaper over the clothes I guess. Washer is 80 series Kenmore, and has performed flawlessly up until recently.
I felt around the inside and I don't feel anything abrasive or sharp in there, yet throw in a new t short and it comes out looking beat.
Any ideas? No change in detergent, no change in water (ie we haven't moved).
Is the thing just old? It's about 5 or maybe 6 years old.
Thanks!
J
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert, Administrators Joined: 7/19/2007(UTC) Posts: 27,455
Was thanked: 4 time(s) in 4 post(s)
|
Try to make a load smaller and/or increase the amount of water.
Check if it tries to agitate during spin. If it does then the gear case (transmission) has gone bad.
The model number you posted is incomplete.
Gene.
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close