Rank: Member
Groups: Registered
Joined: 4/5/2011(UTC) Posts: 2
|
I have a nearly new Kenmore stack washer/dryer (110.88752796) I have purchased a new temperature switch to replace a broken shaft on the present switch. It looks like an easy "plug and play" installation, but I can't figure out how to get behind the front panel. Do I have to take off the dryer front? I see the screws holding plastic clips at each end of the control panel, but removing the screws doesn't seem to loosen anything else. Halp! --please.
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close