Washer Repair

halei · #1 (**permalink**) 02-22-2009, 01:02 PM

This washer will not pump the water out after the wash cycle. It is about 1/2 full and the clothes are wet. I have checked the water pump and the impeller seems to be free. I checked it with the wires unplugged and the continuity was ok. When put back and the power was turned on I get a message that a problem has been detected with the unit. If I press the help button nothing happens. I even reconnected it to the dryer thinking that might have something to do with it. It does not make any difference. This unit will not work at all. Where do I go now?? If I knew what to do I am sure I could repair or install what is needed as I am very handy with most all things. Your reply would be greatly welcomed. Thanks

halei · #2 (**permalink**) 02-22-2009, 01:04 PM

thank you for you reply

beenthereagain · #3 (**permalink**) 02-22-2009, 01:30 PM

the lid switch, should be checked

Gene · #4 (**permalink**) 02-23-2009, 12:59 PM

Did you check the hoses from the tub to the pump and from the pump out?

Gene.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
GE Profile washer	bhartzog1976	Dishwasher Repair	0	12-13-2009 06:04 PM
profile washer	halei	Washer Repair	1	03-10-2009 01:27 PM
GE Profile Washer	cartier	Washer Repair	1	03-24-2008 04:23 PM
GE Profile Washer	samgeno	Washer Repair	0	02-12-2008 05:45 AM
GE Profile washer	jkoz6	Dishwasher Repair	1	12-21-2007 02:32 PM

ge profile washer

Washer Repair

This washer will not pump the water out after the wash cycle. It is about 1/2 full and the clothes