|
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » Washing Machnie shaking uncontrolable on spin cycle |
|
|
By reading any content on this site you agree to AppliancePartsPros.com, Inc. disclaimer and Terms of Use. |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
|
|||
|
Model Number: LNC6760 Brand: Admiral Age: 1 - 5 years
I spoke to you folks about this a few weeks ago. You suggested that I replace the snubber. I did this. No improvement. I also replaced the basket springs. Still no change. I recently tried putting leveling screws on the back of the machine and eliminating the self leveling device. Still no improvement. I try spinning it with nothing in the unit and it still shook out of control. I removed the agitator, the inner tub and ran unit. It ran fine. I put the tub in and ran unit with just the tub and it started to shake out of control again. It acts like the tub is out of balance somehow. This machine has not been used a lot. My wife takes very good care of it. It looks like new! It used to run so nice and smooth. I can't for the life of me figure out what has gone wrong.
Sherm |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
|
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| No spin cycle after towel overload | iwash | Washer Repair | 2 | 10-02-2007 04:01 AM |
| Pump Drains Tub But No Spin Cycle | matt b | Washer Repair | 2 | 09-26-2007 05:51 AM |
| After wash cycle will not drain and spin out | IndianaPanda | Washer Repair | 0 | 08-08-2007 01:15 PM |
| Washing Machine runs through cycle in two minutes | scully27926 | Washer Repair | 1 | 08-07-2007 09:28 PM |
| Niosy spin cycle and leak | jpcamping | Washer Repair | 1 | 07-27-2007 12:02 PM |