Rank: Member
Groups: Registered
Joined: 7/18/2009(UTC) Posts: 10
|
Our Whirlpool Washer will not go into the High Spin at the end of the cycle. It starts to spin, but slowly. If I stop it, open the lid, and wiggle the tub a little, sometimes it will finally go into a high spin. Other times, we just start the spin cycle again, and eventually it will go into the high spin. Any ideas as to what the problem is?
Thanks,
David J. Lee
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 9/10/2007(UTC) Posts: 9,586
Was thanked: 2 time(s) in 2 post(s)
|
You have a worn clutch and probably bad brake shoes, go to my sticky above, "replacing direct drive washer brake shoes" for info on this.
|
|
|
|
Rank: Member
Groups: Registered
Joined: 7/18/2009(UTC) Posts: 10
|
Thanks for the info Rich, but I don't see the Sticky.
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close