|
|||
 |
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » "HF" |
 |
By reading any content on this site you agree to AppliancePartsPros.com, Inc. disclaimer and Terms of Use. |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
10-13-2007, 12:31 PM
|
|||
|
|||
"HF"
Model Number: ghw 9100 lw1 Brand: Whirlpool Age: 1 - 5 years
This indicator has been progessively getting more numerous over the past year. Now it has become problematic. Water flow to the unit is good. Screens are not clogged. When "HF" pops I usually could select Pause/Cancel once and then Hold to Start - that seemed to fix it. Now the washer continues to fill after I "reset" and HP will again stop the cycle. I think HP is stopping the cycle because the washer is overfilling. Could the problem be with the INLET VALVE.. the WATER PRESSURE SWITCH.. or the WATER INLET FLOW METER? Thanks.
    
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| "CLEAN" cycle light always flashing | Tadek | Dishwasher Repair | 9 | 07-22-2008 05:01 PM |
| Starts cycle, gets "stuck" with h2o in bottom, timer is still heard-lights on too. | julialovesjohn | Dishwasher Repair | 1 | 10-03-2007 07:16 PM |
| Only freezes in "quick freeze" mode | alraybonsue | Refrigerator & Freezer Repair | 0 | 09-23-2007 07:10 PM |
| Dispencer "flap" sticking open | mommom02 | Refrigerator & Freezer Repair | 0 | 08-31-2007 11:02 AM |
| Oven oesn't bake/heat and displays a "FS" error message | jnymdnyt | Oven Repair (including Ranges and Cooktops) | 5 | 08-06-2007 06:36 PM |
Linear Mode
