Washer Repair

jsmls · #1 (**permalink**) 11-26-2008, 07:12 PM

I have an old Whirlpool washer. Stops after wash cycle;does not drain, rinse or spin. Have turned timer selector switch to different cycles. It has turned back on to rinse and spin. Now, I can't get it past wash cycle. Some say try lid switch. I will replace. But it looks like selector dial may be bad?? Please advise.
Thanks, Joe

richappy · #2 (**permalink**) 11-27-2008, 07:50 AM

Try lid switch first, your timer is pretty reliable.

jsmls · #3 (**permalink**) 11-27-2008, 10:23 AM

Thanks for the tip. Would you tell me how to lift top of cabinet? I see the selector panel folds back. There is a connection on each front corner. Do they just snap up?
Thanks,
Joe

richappy · #4 (**permalink**) 11-27-2008, 01:27 PM

Pry off both ripply spring retainers, unplug lid switch, and tilt outer panel away.
When putting back, make sure the slots in the bottom of the outer panel go in the frame tabs on the bottom.

richappy · #5 (**permalink**) 11-28-2008, 06:07 AM

Uh, how many people read Chinese!!, probably none, or 1 %

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
WhirlPool Washer	CCS FIXER	Washer Repair	16	03-02-2010 01:56 PM
whirlpool washer	fordpickupgirl	Washer Repair	3	01-09-2010 12:48 PM
Whirlpool washer	wfnelsoniii	Washer Repair	1	06-05-2009 03:18 PM
whirlpool washer	rsr13@hughes.net	Washer Repair	1	05-23-2009 06:31 PM
whirlpool washer	leepahl	Washer Repair	1	11-03-2008 09:47 AM

Old Whirlpool Washer

Washer Repair

I have an old Whirlpool washer. Stops after wash cycle;does not drain, rinse or spin. Have turned timer selector