Rank: Member
Groups: Registered
Joined: 11/30/2010(UTC) Posts: 1
|
Ok i just changed out the bearings on this unit , was working fine, then got it all back together and I keep getting DO error I know its not the Latch assebmly and I just put a new one in thier. Perhpas the control board or i noticed on the diagram that a wire runs to the bottom into the pressure switch is thier any way that the pressure switch could though this error or when I took the drum apart is thier a specifc alignment with respect to the drum and the basket being in a specific postion, thanks for any suggestions.
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close