Washer Repair

robert mcwhirter · #1 (**permalink**) 11-05-2008, 05:12 PM

I got my problem fixed but cant seem to get the clip for top and back to go in place. Can anyone give some help? thanks Robert

magician59 · #2 (**permalink**) 11-06-2008, 07:08 AM

Sometimes you need four hands to replace the cabinets on these machines. Look closely at the base of the chassis. You'll see two tabs that should be vertical, on each side. You start with the cabinet hooking the chassis from underneath. Tilt it down onto the tabs; you sometimes need to squeeze in gently on the sides to get the tabs to line up with the slots in the cabinet. Make sure that the grey or white strips on the back panel are flat, with the "T" flat against the cabinet and panel. Hook the clips in the rear of the slots, and push firmly with the palm of your hand, or push the front of the clips with a large flat-tipped screwdriver. They'll snap back into place.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Cant get the gear box back on	pthompson7	Washer Repair	2	01-24-2010 04:41 AM
Dryer too hot in back and top	donald.may	Dryer Repair	16	09-20-2009 10:35 AM
Converted back to Ng	tnfitz2003	Oven Repair (including Ranges and Cooktops)	1	04-07-2009 06:25 PM
How Do i get the back piece off	JohnD49	Dryer Repair	1	11-22-2008 01:38 AM
Retainer clip on back panel....HOW??	hatsufi	Dryer Repair	0	10-21-2008 12:25 PM

having pronblem with puttin clip back on for top and back

Washer Repair

I got my problem fixed but cant seem to get the clip for top and back to go in place.