|
|||
 |
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » control shut down |
 |
By reading any content on this site you agree to AppliancePartsPros.com, Inc. disclaimer and Terms of Use. |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
10-29-2010, 05:15 AM
|
|||
|
|||
control shut down
Model Number: wfw8410sw02 Brand: Whirlpool Age: 1 - 5 years
When power button is pushed washer control powers up. When start button is pushed door locks but then unlocks after less than 10 seconds and control powers off. If selector is set to drain and spin it works normally for that cycle.Ran auto diagnostic test and all system worked as needed.One fault code of F24 was stored. This code is for the heat sensor or heater. This machine is not equiped with a heater. Replaced CCU but problem persists. Any help?
Ads By Google Related Models 
|
|
See inside of your appliance - diagrams and part photos for virtually every model.
powered by AppliancePartsPros.com |
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Electronic Control Panel or Touch Pad Control Issue? | maxtout4u@aol.com | Dishwasher Repair | 0 | 10-08-2010 11:33 AM |
| No Display Troubleshooting: Control Panel Assy or Electronic Clock Control Board | hddman | Oven Repair (including Ranges and Cooktops) | 0 | 04-26-2010 12:09 PM |
| dryer won't shut off, I replaced timer...still does not shut off. | jwd | Dryer Repair | 0 | 03-20-2010 04:39 PM |
| GE Built-In Oven Control Panel - replace entire assembly or just control kit | boschuser | Oven Repair (including Ranges and Cooktops) | 1 | 01-05-2010 03:11 AM |
| soap control won't stay shut | ice | Dishwasher Repair | 1 | 12-27-2007 11:43 AM |
Linear Mode
