[mande01]

Hello,

I have a hotpoint washer dryer about 3 years old.
Over the past while when I start a wash cycle, it begins the first stage (water in), then it starts spinning the drum, after a while it stops spinning and then the selection knob just keeps turning.

Thing is, if I take out the contents and reduce the load, the cycle can be restarted and will work.

But now it won't carry any load at all.

Is there a load cell somewhere that I can replace, I've opened it up and cleaned all parts, reset the PC board.

Any help would be really appreciated. Even a drawing of the insides with labels and stuff would be fab!!!

Regards,
Derry