[Glen Barclay]

I need to replace the lid switch on my series 90 washer. The consol has two screws in the front (at an angle). I had removed these but still cannot figure out how to get the consol off and get the top of the machine off to access the switch.

[libertyappl]

There should be 2 clips, one on each side about 2 inches from the corners. You can use a putty knife to release these and raise the lid.
Nat

[Drags1998]

Remove the screws, pull console foward 1/2" and rotate over backwards, remove the 3 wire connector to the lid switch, remove the 2 GOLD colored clips, Tilt cabinet foward and slide off the washer.

[Glen Barclay]

thanks for the information

[Glen Barclay]

There does not appear to be any clips there. As I look at it there are plastic somethings at each corner.

[Gene]

Hi Glen,

These clips are #6 on the break down diagram. Insert a flat screwdriver into the front edge of the clip and pry back.

- The part number for the lid switch is AP3094500

Gene.

[Glen Barclay]

Thanks for the great information. I am now in the final stages of putting the machine back together. I really appreciate all of the great info all of you have given me...

[Gene]

You are welcome. Keep us posted.

Gene.